Electrolux EIED200QSW Installation Instructions (English Español Fran - Page 23
Reattaching door and hardware
View all Electrolux EIED200QSW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
Reversing Door 23 Reattaching door and hardware L) Reattaching Door Assembly 1 Open the hinge to a 90 degree angle. 2 Install the door onto the hinge locating pins. N) Reinstalling Trim Ring 1 Close door. 2 Orient trim so UP position is approximately ¾" to the left of top center. Opening in ring should be on the hinge side. 3 Insert trim ring in slots and rotate clockwise approximately ¾". 3 Secure the door with 4 long, course-thread, counter-sunk screws. O) Reinstalling Trim Plug 1 Open door to 90 degree angle. 2 Install trim plug with 1 long, course-thread, panhead screw. 4 Close the door and test the operation of the latch. M) Reversing Trim Ring 1 Trim ring orientation is marked on the back. 2 Remove trim ring cover plate. To remove plate from left, pivot point is down. To remove plate from right, pivot point is up. UP P) Plug in dryer and continue operation. 3 Rotate and move trim ring cover plate to opposite opening in trim and reinsert.