Electrolux EIFLW55HMB Installation Instructions (All Languages) - Page 11

Installation Instructions 11 Performing Installation Cycle If your washer has this console: 1.Empty washer's drum and close door. 2.After you plug in the washer the first time: wake up the washer by pressing any button, rotate cycle knob to hand wash cycle, press the start button and then the cancel button. 3.Wake up the washer again by pressing any button, then immediately and simultaneously press and hold both the eco friendly and my favorite buttons for 5 seconds, or until the LCD display changes. 4.The LCD window will display INSTAL CYCLE and show estimated time of cycle completion. Press the start button. The Installation Cycle will automatically test for if water has been turned on. At cycle completion, the LCD window may display INSTAL PASS!, meaning your new washer is properly installed and ready for use. If it prompts an action such as NO WATER, CHECK HOSES or CALL SERVICE 877 435 3287, review the installation steps and make the necessary corrections before you attempt to use the washer. 5.Your washer will exit the Installation Cycle and return to normal operation the next time you wake it up. NOTE Washer will stay awake for 3 minutes after the Installation Cycle. If you wish to immediately run the washer through a washing cycle, press the cancel button to put the unit to sleep and then rewake it immediately to continue the normal operating mode. 6.Please read the Use & Care Guide and enjoy your new premium washer! If your washer has this console: 1.After you plug in the washer the first time: wake up the washer by pressing any button and then follow the prompts on the LCD User Interface, including language selection. 2.The Installation Cycle will automatically test for, and if water has been turned on. At cycle completion, the LCD window may display INSTAL PASS!, meaning your new washer is properly installed and ready for use. If it prompts an action such as NO WATER, CHECK HOSES or CALL SERVICE 877 435 3287, review the installation steps and make the necessary corrections before you attempt to use the washer. 3.Your washer will exit the Installation Cycle and return to normal operation the next time you wake it up. NOTE Washer will stay awake for 3 minutes after the Installation Cycle. If you wish to immediately run the washer through a washing cycle, press the cancel button to put the unit to sleep and then rewake it immediately to continue the normal operating mode. 4.Please read the Use & Care Guide and enjoy your new premium washer!