Electrolux EIGD55HIW Product Specifications Sheet (English) - Page 2

Gas Front Load Dryer EIGD55H IW Gas Dryer Specifications • Product Weight - 130 Lbs. • An electrical supply with grounded three-prong receptacle is required. The power supply circuit must be installed in accordance with current edition of National Electrical Code (ANSI/NFPA 70) and local codes & ordinances. (Do not use same circuit as washer.) • Voltage Rating - 120V / 60 Hz / 15 Amps • Amps @ 120 Volts = 9 Amps • Connected Load (kW Rating) @ 120 Volts = 1.1 kW • Equipped with 120V 3-wire power supply cord, approx. 60" long. • Always consult local and national electric & gas codes. • Can be installed alone, with or without optional 15" drawer pedestal, or stacked above matching Electrolux Washer, which requires installation of optional dryer stacking kit. (For installation details, refer to instructions included with optional pedestal or stacking kit or on web.) • Can be built in with matching Electrolux Washer in under-counter, recessed or closet installation. Installations requiring countertop and / or cabinetry will require custom building. (Refer to Built-In Installations on this page for cutout dimensions. For additional installation details, refer to Product Installation Guide on web.) • Closet installation requires vented door with 2 unobstructed louvered openings, minimum 60 sq. in. each, located 3" from top and bottom of door. Full-length 120 sq. in. opening also acceptable. Allow 1" clearance between door and fronts of units. • Do NOT install in area exposed to dripping water or outdoor weather conditions, or where gasoline or other flammables, including automobiles, are kept or stored. • Floor MUST be solid with 1" maximum slope. To ensure vibration or movement does not occur, reinforcement of floor may be necessary. Do NOT install on carpeted surface. • Dryer MUST exhaust to outside of building, NOT into any concealed space. • Dryer equipped for 4-way venting and approved for up to 125-foot- equivalent of duct length, determined by length of run and number of elbows needed. • Exhaust installation requires minimum 4"-diameter rigid or flexible metal duct with approved vent hood having swing-out damper(s). Do NOT use flexible plastic or metal foil duct and use shortest run possible. • Gas supply line should be 1/2" pipe and MUST have individual shutoff valve. • Leveling legs supplied to level dryer properly and reduce excessive noise and vibration. Note: For planning purposes only. Refer to Product Installation Guide on the web at electroluxappliances.com for detailed instructions. Optional Accessories • Drawer Pedestals - Island White (PN # EPWD15IW). • Dryer Stacking Kit - (PN # ESTACKIT). • Mobile Home Installation Kit - (PN # 137067200). • LP Gas Conversion Kit - (PN # PCK4300). Electrolux Major Appliances, N.A. USA • 10200 David Taylor Drive • Charlotte, NC 28262 • 1-877-4electrolux (1-877-435-3287) • electroluxappliances.com CANADA • 5855 Terry Fox Way • Mississauga, ON L5V 3E4 • 1-800-265-8352 • electroluxappliances.ca EIGD55H 04/11 © 2011 Electrolux Home Products, Inc. High standards of quality at Electrolux Home Products, Inc. mean we are constantly working to improve our products. We reserve the right to change specifications or discontinue models without notice. Printed in the U.S.A.