Electrolux EIMED60JIW Installation Instructions (All Languages) - Page 18

18 Installation Instructions Performing Installation Cycle WARNING FIRE HAZARD Before operating the dryer, make sure the dryer area is clear and free of combustible materials, gasoline, and other flammable vapors. Also see that nothing (such as boxes, clothing, etc.) obstructs the flow of combustion and ventilation air. NOTE On gas dryers, before the burner will light, it is necessary for the gas line to be bled of air. If the burner does not light within 45 seconds the first time the dryer is turned on, the safety switch will shut the burner off. If this happens, press cancel and wait 5 minutes before making another attempt to light. With your dryer in final location, perform an Installation Cycle to assist in proper installation. If your dryer has this console: 2a 2b 1. Empty dryer's drum and close door. 13 4 2. After you plug in the dryer the first time: wake up the dryer by pressing any button, rotate cycle knob to cycle one up from lower right position (1), press the start button (3) and then the cancel button (4). 3. Wake up the dryer again by pressing any button, then immediately and simultaneously press and hold buttons 2a and 2b for 5 seconds, or until the LCD display changes. 4. The LCD window will display INSTAL CYCLE and show estimated time of cycle completion. Press the start button. The Installation Cycle will automatically perform various diagnostic routines. At cycle completion, the LCD window may display INSTAL PASS!, meaning your new dryer is properly installed and ready for use. If it prompts an action such as SERVICE CORD, NO GAS or call service 877 435 3287, review the installation steps and make the necessary corrections before you attempt to use the dryer. 5. Your dryer will exit the Installation Cycle and return to normal operation the next time you wake it up. NOTE Dryer will stay awake for 3 minutes after the Installation Cycle. If you wish to immediately run the dryer through a drying cycle, press the cancel button to put the unit to sleep and then rewake it immediately to continue the normal operating mode. 6. Please read the Use & Care Guide and enjoy your new premium dryer! If your dryer has this console: 1. After you plug in the dryer the first time: wake up the dryer by pressing any button and follow the prompts on the LCD User Interface, including language selection. 2. The Installation Cycle will automatically test for correct cord connection (on electric models), presence of gas supply (on gas models) and free flow of exhaust vent. At cycle completion, the LCD user interface may display INSTAL PASS!, meaning your new dryer is properly installed and ready for use. If it prompts an action such as SERVICE CORD, NO GAS or call service 877 435 3287, review the installation steps and make the necessary corrections before you attempt to use the dryer. 3. Your dryer will exit the Installation Cycle and return to normal operation the next time you wake it up. NOTE Dryer will stay awake for 3 minutes after the Installation Cycle. If you wish to immediately run the dryer through a drying cycle, press the cancel button to put the unit to sleep and then rewake it immediately to continue the normal operating mode. 4. Please read the Use & Care Guide and enjoy your new premium dryer!