Electrolux ELFW7437AG Complete Owners Guide - Page 16
INSTALLATION, Reversing the door
View all Electrolux ELFW7437AG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
16 INSTALLATION Reversing the door NOTE Door reversibility is available on all models. IMPORTANT BEFORE YOU REVERSE WASHER DOOR: 1. Be sure you have adequate swing area before reversing door. 2. Gather your tools - including a screw driver with a #2 square bit and plastic knife (or small, flat prying tool that won't damage paint). 3. Protect flat work surface, such as top of washer or floor near washer, with a soft cloth or towel. 4. Be sure washer is unplugged from power source! Tools needed for reversal: Screwdriver with #2 square bit Plastic knife WARNING ELECTRICAL SHOCK HAZARD Failure to disconnect power source before servicing could result in personal injury or even death. Removing door assembly 1. Completely open the door to expose all four hinge screws. 2. Remove all four hinge screws with #2 square bit driver. Save for reinstalling later. 4. While supporting the door with one hand, pinch the tabs to release the plastic terminal cap from the hinge plate. IMPORTANT x4 Fine Thread Take care not to pull the door away from the washer until you remove the wiring harness terminal cap. 3. Hold the door with one hand supporting the handle area and one hand supporting the hinge. While supporting the door at the hinge, press firmly with the other hand until the locating pins on the back of the hinge plate dislocate from the front panel. 5. Set the door face down on a flat surface protected by soft cloth or towel.