Electrolux ELFW7537AW Complete Owners Guide - Page 31

Door stand ventilation, Trapped item detection

Page 31 highlights

31 CONTROLS AND SETTINGS Trapped item detection If an item is detected to be trapped between the door and the door gasket, the washer will pause the cycle and play an alert chime. The LED will display a loop of "CLEAr door" as shown below until the cancel button is pressed. Press the cancel button to unlock the door and remove the trapped item, then close the door and restart the cycle. (60 sec loop) (60 sec loop) Door stand ventilation Help prevent odor buildup and reduce humidity between washes by utilizing your washer's door stand ventilation feature. Open the door, locate the stand below the door latch and rotate the stand counterclockwise to unlock it.  NOTE If unable to rotate the stand by hand, a coin or flat blade screw driver can be used. The stand is spring loaded and will extend. Rotate it clockwise to lock in the extended position. 2 3 1 To disengage the stand, rotate to unlock, push the stand in and rotate to lock position.  NOTE If door stand will not turn to locked position, fully turn it to unlock position and try to lock again.

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52

31
Door stand ventilation
Help prevent odor buildup and reduce
humidity between washes by utilizing your
washer’s door stand ventilation feature.
Open the door, locate the stand below the
door latch and rotate the stand counter-
clockwise to unlock it.
The stand is spring loaded and will extend.
Rotate it clockwise to lock in the extended
position.
1
2
3
Trapped item detection
If an item is detected to be trapped between
the door and the door gasket, the washer
will pause the cycle and play an alert chime.
The LED will display a loop of “CLEAr door”
as shown below until the cancel button is
pressed. Press the cancel button to unlock
the door and remove the trapped item, then
close the door and restart the cycle.
(60 sec loop)
(60 sec loop)
NOTE
If unable to rotate the stand by hand, a coin
or flat blade screw driver can be used.
NOTE
If door stand will not turn to locked
position, fully turn it to unlock position and
try to lock again.
CONTROLS AND SETTINGS
To disengage the stand, rotate to unlock, push
the stand in and rotate to lock position.