Electrolux EW30EC55G Use and Care Guide - Page 13
Ope Ting, Smnglesurface D Ant
View all Electrolux EW30EC55G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
ng Surface Controls OPE TING THE SmNGLESURFACED ANT The cooktop has single radiant surface elements at 2 locations; the right and left rear (Figs. 1 & 2) element positions. To Operate the Single Surface Element 1. Place correctly sized cookware on the radiant surface element. 2. Touch and hold the (D key pad until a beep sound. The power indicator POWER light above the (D will turn ON. Note: If no other key pad is touched within POWER 20 seconds the request to Power ON the cooktop will clear. . Touch and hold the [] pad for the desired element position until a oNo_F beep is heard. The indicator light located above the [] pad will glow. ONO_F Note: If no further pads are touched within 10 seconds the request to power the element ON will clear. . Touch hi + pad once to turn ON the power level to HI. Touch rned pad once for MEDIUM, touch = Io pad once for power level Fig. 1 to LO or touch ! pad once to set the power level to KEEP warm WARM setting. . Each touch of the hi + or = Io pad will increase or decrease the power level. Lo is the lowest power level available. Note: The power level may be adjusted at any time while the element is ON. Fig. 2 . When cooking has been completed touch the [] pad once to turn the element OFF ONO_F and if no other surface element is used touch the (:D key pad to turn off the cooktop. POWER Each surface element provides a constant amount of heat at each setting. A glowing red surface heating area extending beyond the bottom edge of the cookware indicates the cookware is too small for the surface heating area. Note: The Hot Surface Indicator Light will turn ON if the cooktop is still hot and will remain ON until the heating surface area has cooled sufficiently.