Electrolux EW30GF65G Use and Care Manual - Page 53
Cleaning cooktop and parts, IMPORTANT
View all Electrolux EW30GF65G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 53 highlights
Care and Cleaning 53 Cleaning cooktop and parts The cooktop is designed to make cleaning easier. Because the gas burners are sealed, cleanups are easier when spillovers are cleaned up immediately. IMPORTANT The cooktop is not removable. Do not attempt to remove or lift the cooktop. Cooktop If a spill occurs on or in the recessed or contoured areas, blot up spill with an absorbent cloth. Rinse with a clean, damp cloth and wipe dry. Do not use harsh abrasive cleaners on the cooktop. They can scratch the porcelain. Completely rinse any mild cleaners used from the surface or the porcelain cooktop may become damaged during future heating. Do not use spray oven cleaners on the cooktop. Burner grates The burner grates are dishwasher safe and may be cleaned in the dishwasher. Remove any excessive soils before placing in the dishwasher. Your appliance is shipped with the burner heads and burner caps in the correct locations. Before using your gas range be sure to: • Follow the installation instructions before installing. • Remove all packing tape from cooktop area. To remove: Should you ever need to remove the burner cap for cleaning, simply lift the cap off the burner head. To replace: 1. Pair up burner caps sizes with corresponding burner heads. 2. Align burner cap ignition area to the burner head ignition area. See illustration. 3. Place the burner cap vane slots onto the burner head vanes. Before using make sure the burner cap fits flush with the burner head. Burner Cap Burner cap vane slots Burner heads & caps • Do not remove any parts from the cooktop until they have completely cooled and are safe to handle. Do not operate the surface burners without the burner caps. IMPORTANT Burner cap ignition area Burner head ignition area Burner port Do not allow food, spills, cleaning agents or any other material to enter the gas burner port -Fig. 1-. To clean: The ports (or slots) around the burner heads must be routinely cleaned. If residue still remains in these ports, use a small-gauge wire or needle to clean the slots or holes. For proper flow of gas and ignition of the burner- Always keep the burner caps in place whenever the gas burners are in use. Burner head vanes Burner Head Fig. 1 Double ring burner heads & caps The glass in the double ring burner is designed to fit loosely. Clean with normal non-abrasive glass cleaners and thoroughly dry before replacing.