Electrolux EWFLW65IMB Installation Instructions - Page 13
Reversing Door
UPC - 012505378966
View all Electrolux EWFLW65IMB manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
Reversing Door 13 Preparing to reverse door swing 1 Be sure you have adequate swing area before reversing door. 2 You will need a screw driver with a #2 square bit. 3 Protect flat work surface, such as top of washer or floor near washer, with a soft cloth or towel. 4 Be sure washer is unplugged from power source! WARNING ELECTRICAL SHOCK HAZARD Failure to disconnect power source before servicing could result in personal injury or even death. Removing door and hardware Tools needed: Screwdrivers with #2 square & straight bit A) Removing Trim Ring 1 Open the door to a 90 degree angle. 2 Remove and save the trim plug and long, course-thread, panhead screw. B) Removing Door from Hinge 1 Reopen door to 90 degree angle. 2 Remove 4 long, course-thread, counter-sunk hinge screws from door. 3 Close the door. 4 Rotate the door trim approximately ¾" counter-clockwise and pull it away from the front of the door. 3 While supporting the weight of the door with both hands, separate the door from the hinge. 4 Gently place the door face down on a flat, covered work surface.