Electrolux EWMED70JIW Installation Instructions (All Languages) - Page 3
Installation Requirements - installation instructions
UPC - 012505382840
View all Electrolux EWMED70JIW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 3 highlights
Installation Requirements 3 Please read and save this guide Questions? Thank you for choosing Electrolux, the new premium brand in home appliances. These Installation Instructions are part of our commitment to customer satisfaction and product quality throughout the life of your new appliance. For toll-free telephone support in the U.S. and Canada: 1-877-4ELECTROLUX (1-877-435-3287). For online support and product information visit http://www.electroluxappliances.com. Installation Checklist Exhaust Venting Free-flowing, clear of lint buildup 4 inch (102 mm) rigid or semi-rigid ducting of minimal length and turns NO foil or plastic venting material Approved vent hood exhausted to outdoors Leveling Dryer is level, side-to-side and front-to-back Cabinet is setting solid on all corners Gas Supply (Gas Dryer) Manual shutoff valve present in supply All connections sealed with approved sealer and wrench tight Conversion kit for LP system Gas supply turned on No leaks present at all connections - check with soapy water, NEVER check with flame 240v Electric Supply (Electric Dryer) Approved NEMA 10-30R or 14-30R service cord with all screws tight on terminal block Approved strain relief installed Terminal access cover installed before initial operation Door Reversal Follow detailed instructions in this guide Test hinge and latch for function Electrical Power House power turned on Dryer plugged in Final Checks Installation Instructions and Use and Care Guide read thoroughly Door latches and drum tumbles when cycle starts Registration card sent in Pre-installation requirements Tools and materials needed for installation: or or Adjustable Phillips, straight, & Adjustable pliers square bit screwdrivers wrench Universal wrench supplied with matching washer Pipe wrench for gas supply LP-resistant thread tape (for natural gas or LP supply) Carpenter's level External vent hood 4 inch, rigid metal or semi-rigid metal exhaust duct work 3-wire or 4-wire 4 in. 240 volt cord kit (10.2 cm) (electric dryer) clamp gas line shutoff valve (gas dryer) ½" NPT union flare adapters (x2) and flexible gas supply line (gas dryer) Metal foil tape (not duct tape)