Emerson CF850 Owner Manual - Page 9

Installation of Lower Light Glass 1. Screw three candelabra bulbs into the light kit assembly sockets (Figure 16). 2. Unscrew the finial nut, bowl cap, hex jamnut and rubber washer from the light kit threaded nipple (Figure 17). 3. Position the glass shade over the threaded nipple in the light kit plate assembly. 4. Reinstall the rubber washer, hex jamnut, bowl cap and finial nut onto the threaded nipple (Figure 17). CANDELABRA BULBS (3) NOTE: Periodically check that the glass bowl is seated correctly in the light kit assembly and the hex jamnut and finial nut are tightly fastened. Figure 16 5. Assembly of the ceiling fan is now complete. Restore electrical power to the branch circuit at the fuse box or breaker panel. 6. Slide the small wood penadant onto the center (fan speed) chain, secure by connecting the coupling to the chain. Slide the large wood penadant onto the off-center (fan light) chain, secure by connecting the coupling to the chain. (Figure 18). 7. If airflow is desired in the opposite direction, turn the fan off and wait for the blades to stop turning. Then slide the reversing switch, located on top of the fan motor assembly, to the opposite position (Figure 19) and turn the fan on again. The blades will turn in the opposite direction and reverse the airflow. GLASS SHADE RUBBER WASHER HEX JAMNUT BOWL CAP Figure 17 FINIAL NUT LIGHT KIT SOCKETS FAN SPEED CHAIN SMALL WOOD PENDANT Figure 18 FAN LIGHT CHAIN LARGE WOOD PENDANT COUPLING (2) AIRFLOW REVERSING SWITCH FAN MOTOR ASSEMBLY Figure 19 9 U.L. Model No.: CF850