Epson 1700C Quick Start - Page 1

TART S HERE Connect the projector to your notebook 1 Locate the required cables: Power cord VGA computer cable 2 Connect the computer cable to the blue Computer/Component Video port on the projector. Epson® PowerLite® 1700c/1710c Quick Setup 3 Connect the other end to your notebook's video-out or monitor port. NOTE: If your notebook has a DVI connector, you need to use an optional DVI-to-VGA adapter with the included computer cable (see your computer's documentation). 4 Connect the power cord to the projector, then plug the other end into an electrical outlet. Turn on your equipment 1 Turn on your notebook. 2 Open the A/V Mute slide. NOTE: The slide must be opened completly. 3 Make sure the Power light is orange and not flashing. 4 Press the Power button to turn on the projector. Power light Power button CAUTION: Before unplugging the projector... Shut down the projector properly: 1. Press the Power button twice. 2. When the orange light stops flashing and the projector beeps, you can unplug the projector. Follow these instructions to connect the projector to your notebook. For other setup options, see your User's Guide. Adjust the image 1 If you've turned on your notebook and you don't see an image, press the Source Search button on the projector or remote control to select the image source. NOTE: If you still see a blank screen or have other display problems, see the troubleshooting tips on the back of this sheet. 2 To raise the image, press the blue foot release button for the front adjustable foot and lift the front. Release the button to lock the foot in position. 3 Turn the focus ring to sharpen the image. Turn the zoom ring to reduce or enlarge the image. Focus Zoom 4 If your image looks like or , you've placed the projector off to one side of the screen at an angle. Place it directly in front of the center of the screen, facing the screen squarely. 5 If your image looks like or , press the or buttons on the projector to correct it. Turn over