Epson 2255U Operation Guide - EasyMP Monitor v4.57 - Page 32

Monitoring window layout 32 Internal temperature error G Error information Shows a warning/problem status using the following icons. Replace Lamp*6 Replace Lamp (Lamp 1) Replace Lamp (Lamp 2) Lamp error (Lamp 1) Lamp error (Lamp 2) Lamp failure at power on (Lamp 1) Lamp failure at power on (Lamp 2) High-temperature warning Replace Air Filter No Air Filter Low Air Flow Air Flow Sensor Err. Supply System Error (Ballast 1) Supply System Error (Ballast 2) Cinema filter warning Shutter warning Lamp Cover Open Lamp Error Lamp Error (Lamp 1) Lamp Error (Lamp 2) Lamp failure at power on Lamp failure at power on (Lamp 1) Lamp failure at power on (Lamp 2) High internal temperature error Low air flow error Air filter air flow sensor error Internal Error Fan error Sensor error Supply System Error (Ballast) Supply System Error (Ballast 1) Supply System Error (Ballast 2) Auto Iris Error Cinema filter error Shutter error Cooling system error (Peltier element) Cooling system error (pump) Exhaust vent shutter error Easy Interactive Function Error Projector Direction Warning Laser Warning Phase Difference Plate Error Lens Shift Error Other Warning Other error Obstacle Detection warning Obstacle Detection Error Lamp Mismatch Warning Incorrect Installation Position/Direction Warning Power Voltage Error No Lens Error Laser Error *1 When Temperature level display group view is set to On at Environment setup in the Tool menu, an icon indicating the internal temperature of the projector will be displayed on top of the projector icon. The default setting is Off. *2 Check the following items. - Check that the projector's power is turned on. - Check that the LAN cable is connected. - Check that Standby Mode is set to Communication On (or Network On) or Network Monitoring is set to On in the projector's configuration menu. *3 Check that the projector has been correctly connected to the network. *4 It describes DVI-D if the projector is equipped with both DVI-D and HDMI input terminal. *5 It describes HDMI if the projector is equipped with both DVI-D and HDMI input terminal. *6 You can display Replace Lamp at any time by setting a preset in the Environment setup in the Tool menu. q Detectable error information differs with the projector you are using.