Epson 4880 Start Here - Page 3

6 After installing all 8 cartridges, lower the ink levers. The printer begins charging the ink delivery system and the pause light flashes. 7 After approximately 2 minutes, ink lever messages appear on the LCD. Follow the instruction to raise or lower the ink levers. Caution: Charging takes about 8 minutes. Never turn off the printer, open the cover, remove the rear cover, release the paper lever, or remove the ink cartridges or maintenance tank while the pause light is flashing, or you may damage the printer. 8 When READY appears on the LCD display, charging is complete. Close the ink compartment covers. Caution: Always turn off the printer using the power button. Then wait until the LCD display turns off. This ensures that the print head is safely capped. Install Software for a USB Connection Your printer software works with Windows Vista,® Vista x64, Windows® XP, XP Professional x64 Edition, and Macintosh® OS X 10.4.9 or higher, or 10.5 or higher. If you are using the USB interface, follow the steps below to install the printer software. If you are using the Ethernet interface, follow the steps in Chapter 1 of the Printer Guide to configure the printer and install the software. When you're finished installing software, update the printer firmware if necessary. See chapter 1 of the Printer Guide for instructions. Macintosh 1 Make sure your Macintosh and printer are turned on. 2 Connect the USB cable. 3 Insert the Epson Stylus Pro 4880 printer CD. If necessary, double-click the Epson CD-ROM desktop icon. 4 Double-click the Epson icon. 5 Click Install. Note: If you see a message that the installer has detected an older version of EpsonNet Config on your system, you must uninstall the older version before you can install the new one. To uninstall, drag the EpsonNet folder to the trash. Then reinstall your printer software. 6 Follow the on-screen instructions to install all the necessary software and manuals, and place a link to the Epson Professional Imaging Website on your desktop. 7 Open the Applications folder, then open the Utilities folder. Open the Printer Setup Utility and click the Add icon at the top of the printer list window. (If you see a message that you have no printers available, click Cancel.) 8 Select the Stylus Pro 4880 and click Add. 9 Close the printer list and any open windows, then eject the CD.