Epson 525W Quick Setup - Page 2
Adjust the image, Using the remote control, Project wirelessly from acomputer - driver
View all Epson 525W manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 2 highlights
Adjust the image 1 If you don't see an image, press the Source Search button on the projector or the remote control to select the image source. Note: If you still see a blank screen or have other display problems, see the troubleshooting tips on the back of this sheet. 2 To raise the image, press the foot release button and lift the front of the projector. Release the button to lock the foot in position. Using the remote control Make sure the batteries are installed as shown (two AA batteries). Turn projector on and off Choose which source to display 3 Press the Wide or Tele buttons on the projector to reduce or enlarge the image. 4 Turn the focus ring to sharpen the image. 5 If your image looks like or , you may have placed the projector off to one side of the screen at an angle. Place the projector directly in front of the center of the screen, facing the screen squarely. If you can't move the projector, press the or button on the projector to open the keystone correction menu then use the Wide or Tele buttons to correct the image. 6 If your image looks like or , you can press the or button on the projector to correct it. Access projector menus Switch between computer and interactive pen Navigate projector menus Turn off projector display Get solutions to common problems For more information on using the remote control, see the online User's Guide. Project wirelessly from a computer Follow the steps here to connect the projector over a wireless network. You will need the optional wireless LAN module (part number V12H418P12). 1 To install the optional wireless LAN module, first remove the screw as shown. 2 Connect the wireless LAN module to the USB-A (flat) port. 3 To configure your projector for wireless projection, do one of the following: • If you're using the optional Quick Wireless Connection USB key (Windows only, part number V12H005M09), press the LAN button on the remote control. When you see SSID and IP address information on the screen, remove the wireless LAN module and connect the key to the projector's USB-A port. Look for the displayed message, remove the key, and connect it to a USB port on your computer. Follow your computer's on-screen instructions to install the driver, then reconnect the wireless LAN module to the projector's USB-A port. For details, see the online User's Guide. • If you're not using the key, continue with step 4.