Epson 595Wi Start Here - Page 3

2 Calibrate Calibration coordinates the position of the pen or your finger with the location of your cursor. If the pen or finger position and cursor location don't match, you can perform auto calibration, or you can calibrate manually for even greater accuracy. You don't need a computer, and you won't need to calibrate again unless the projector or image is moved, or the image is resized. Pen Calibration 1 To start pen calibration, press the User button on the remote control. 2 When you see the Auto Calibration screen, do one of the following: • Press to run auto calibration, then wait until calibration is complete. • Select No, then press and follow the steps below to calibrate manually. 3  Select Manual Calibration, then press . 4 When you see the Manual Calibration screen, press to select Yes. 5 Touch the circles on the screen with your pen to perform manual calibration. Finger Touch Calibration 1 To start finger touch calibration, press the User button on the remote control. 2  When you see the Auto Calibration screen, do one of the following: • Press to run auto calibration, then wait until calibration is complete. • Select No, then press and follow the steps below to calibrate manually. 3  Select Touch Unit Setup, then press 4  Select Installation Pattern and press the on-screen instructions. . . Follow 5 Select Touch Calibration, then press . 6 When you see the Touch Calibration screen, press to select Yes. A green circle appears in the upper left corner of your projected image. 7 Touch and hold the center of the circle with your finger until the circle disappears and another one appears. Note: Make sure you touch the center of each circle; otherwise the calibration may not be accurate. 8 Continue until all of the circles disappear. For more detailed instructions, see the online BrightLink User's Guide.