Epson 695Wi Start Here - Page 5
Using the Remote Control, Calibration, Finger Touch Calibration
View all Epson 695Wi manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
Using the Remote Control Turn projector on/off Select from various image sources connected to the projector Access menu system for additional adjustments Calibrate Page through documents Temporarily turn off image and sound Switch between PC Interactive and PC Free Annotation Enter Zoom in and out Stop video action Display Home screen For more information on using the remote control: •• See the online BrightLink User's Guide •• Watch a video or two at www.epson.com/brightlinkvideos (U.S.) or www.epson.ca/brightlinkvideos (Canada) Calibration Calibration coordinates the position of the pen or your finger with the location of your cursor. If the pen or finger position and cursor location don't match, you can perform auto calibration, or you can calibrate manually for even greater accuracy. Note: You must perform pen calibration before calibrating finger touch. Pen Calibration 1 To start pen calibration, press the User button on the remote control, or press the Home button on the remote control and select Auto Calibration. 2 When you see the Auto Calibration screen, do one of the following: •• Press to run auto calibration, then wait until calibration is complete. •• Select No, then press and follow the steps below to calibrate manually. 3 Select Manual Calibration, then press . 4 When you see the Manual Calibration screen, press to select Yes. 5 Touch the center of the circles on the screen with your pen to perform manual calibration. Finger Touch Calibration Note: If you are unable to perform finger touch calibration, make sure that the installer properly installed the Touch Unit and performed the angle adjustment. 1 To start finger touch calibration, press the User button on the remote control, or press the Home button and select Auto Calibration. 2 W hen you see the Auto Calibration screen, select No, then press and follow the steps below. 3 Select Touch Unit Setup, then press . 4 Select Touch Calibration, then press . 5 When you see the Touch Calibration screen, press to select Yes. A green circle appears in the upper left corner of your projected image. 6 Touch and hold the center of the circle with your finger until the circle disappears and another one appears. Note: Make sure you touch the center of each circle; otherwise the calibration may not be accurate. 7 Continue until all of the circles disappear. For more detailed instructions, see the online BrightLink User's Guide.