Epson 835p Operation Guide - EMP Monitor v4.22 - Page 21
Selecting display items, Select Option from the View menu. - replacement lamp
UPC - 010343851160
View all Epson 835p manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
Monitoring window layout 20 Error information: Shows a notification or warning/problem status using the following icons. Clean Air Filter Notice Lamp Error Replace Lamp*4 Lamp failure at power on High-temperature warning High internal temperature error Replace Air Filter Internal Error No Air Filter Fan error Low Air Flow Air Flow Sensor Err. Low air flow error Air filter air flow sensor error Lamp Cover Open Sensor error Supply System Error (Ballast) Auto Iris Error Other error *1 When "Temperature level display group view" is set to "On" at "Environment setup" in the "Tool" menu, an icon indicating the internal temperature of the projector will be displayed on top of the projector icon. The default setting is "Off". *2 Check the following items. • Check that the projector's power is turned on. • Check that the LAN cable is connected. • Check that "Network Monitoring" is set to "ON" or "Standby Mode" is set to "Network ON" in the projector's configuration menu. *3 Check that the projector has been correctly connected to the network. *4 You can display the "Replace Lamp" warning at any time preset in "Environment setup" in the "Tool" menu. TIP • The projector information that is generated when a problem is detected is stored until EMP Monitor is closed. The EMP Monitor displays will not be updated automatically even if the projector status returns to normal. Click [Refresh] in the main window to update the status. • Detectable error information differs with the projector you are using. f Selecting display items You can select only the required items to be displayed in "Detail list view". PROCEDURE 1 Select "Option" from the "View" menu. The "Option" window will be displayed.