Epson ActionNote 895CX Product Information Guide - Page 10

EPSON ActionNote 890 Series System l/O Address Map Hexadecimal Address 000-01F 020-03F 040-05F 060-06F 070-07F 080-09F 0A0-0BF 0C0-0DF 0F0 0F1 0FB-0FF 100-1EF 1F0-1F8 200-207 208-277 278-27F 2F8-2FF 300-31F 360-36F 378-37F 380-38F 3A0-3AF 3B0-3BF 3C0-3CF 3D0-3DF 3E0-3EF 3F0-3F7 3F8-3FF Device DMA Controller 1 lnterrupt Controller Timer/Counter Keyboard Controller RTC NMI DMA Page Register Interrupt Controller 2 DMA Controller 2 Clear Math Coprocessor Busy Reset Math Coprocessor Math Coprocessor I Available Hard Disk Drive Game Port Optional Sound Card Parallel Port 2 I Serial Port 2 Prototype Card Reserved Parallel Port 1 SDLC Bisynchronous 2 Bisynchronous 1 Mono Display Printer Adapter Reserved Color/Graphics Monitor Adapter PCMCIA Controller I Diskette Drive Controller Serial Port 1 Installation/Support Tips Using Low Battery Save to HDD and Instant On I The ActionNote 890 series hard disk drive is partitioned at the factory so that these options can be used. A 25MB area is set aside for the saved data; this ensures that there is I enough space for all memory configurations. I To prepare the hard disk drive, run the PHDISK utility, located in the C:\PM directory. You also need to run this utility if you upgrade your system memory. Type the following command at the DOS prompt and press Enter: PHDISK/CREATE I If you install a new hard disk drive and want to use the Low Battery Save to HDD or Instant On options, you need to leave sufficient space on the disk unpartitioned. The amount of space should equal the system memory plus 2MB. After you run FDISK to partition the drive, you need to run the PHDISK utility to configure the storage space on the drive. I In Windows 3.1, when the computer is turned on after using the Low Battery Save to HDD or Instant On options, the PCMCIA services are not reinitialized. The computer recognizes SRAM PC cards, but does not recognize most other PC cards. You must reboot to reinitialize the services. I Using an External Monitor I When you connect an external monitor, make sure you turn it on before you turn on the computer. The ActionNote automatically detects the external monitor and displays data on its screen. Press Fn F10 to switch your display from the monitor to the LCD screen or to display on both screens simultaneously. I Using a Serial Mouse If you connect a serial mouse, you must use the Setup program to disable the built-in touchpad. AN890-10 8/25/95