Epson ActionPC 3000 User Manual - Page 29
Epson ActionPC 3000 Manual
![]() |
View all Epson ActionPC 3000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 29 highlights
Setting the floppy seek option If you set the Disk drive boot sequence option to C: only, you can disable the Floppy seek option so the system does not try to access the diskette drive at startup. Disabling the Floppy seek option decreases the time needed to boot the system. Disabling the SETUP prompt The Display SETUP prompt during POST option allows you to disable the message Press to enter SETUP that you see during power-on diagnostics. You may want to disable this prompt to prevent unauthorized users from seeing the SETUP prompt. Even when the message is disabled, however, you can still start SETUP by pressing F2 within the allowed amount of time. Disabling power-on diagnostic error messages The Pause on POST errors option allows you to disable the error message and the message Press to r e s u m e , to Setup that you see when the system identifies a configuration error. If you disable this option, the system ignores configuration errors it finds during power-on diagnostics and starts as it normally would. It's a good idea to keep this option enabled. Disabling the system summary screen By disabling the System summary screen at boot option, you can disable the system summary screen that you see when you start the system. If you disable this option, your system starts up faster. You can see the same screen by selecting the System Summary option from the Main Menu. (See page 1-19.) 1-14 Setting Up your System
![](/manual_guide/products/epson-actionpc-3000-user-manual-dce8eaf/29.png)