Epson ActionPrinter 3250 User Setup Information - Page 4
your changes. All new settings remain in effect until
View all Epson ActionPrinter 3250 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
Make sure the printer is turned off and paper is loaded. Remove the narrow cover from the printer. To enter the default settings mode, hold down the YES button while you turn on the printer. IYEIS 4. The printer prints a series of questions about your printer settings. Press the YES and NO buttons to respond and make your changes. All new settings remain in effect until you change them again. YES NO Note: 5. Turn off the printer at any time to exit the default settings mode; then replace the narrow cover. You can change the printer settings listed here: Character table 437, 850,860, 863, 865 Page length* 11", 12", 8.5", 70/6" Skip over perforation* On. Off Tear-off position* On cutter, Above cutter TOF position -3, -2, -1, ±0, +1, +2, +3 Graphic print direction Unidirectional, Bidirectional Download On, Off Auto line feed On, Off Hex dump/Demonstration Hex dump, Demonstration * Available only if optional push tractor is installed