Epson Artisan 710 Start Here - Page 2
Load paper - cartridges
View all Epson Artisan 710 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 2 highlights
2 Unpack the ink cartridges. 3 Slide the edge guides against the paper. 3 Remove only the yellow tape from each cartridge. Caution: Don't remove any other seals or the cartridges may leak. 4 Lower the photo tray. 4 Insert the cartridges in the holder for each color. Press each cartridge down until it clicks. 5 Squeeze the edge guides and slide them out. Then insert 4 x 6-inch or 5 x 7-inch photo paper with the glossy or printable side face-down. 5 Lower the scanner. 6 Wait while ink charges. Charging takes about 5 minutes. Note: Your Artisan 710 Series ships with full cartridges and part of the ink from the first cartridges is used for priming the Artisan 710 Series. Replacement cartridges will print more pages. Caution: Don't turn off the Artisan 710 Series while the ink system is charging or you'll waste ink. 5 Load paper The paper cassette has 2 trays. The main tray is for letter-size, legal-size, or 8 x 10-inch paper. The photo tray is for 4 x 6- or 5 x 7-inch photo paper. 1 Pull out the paper cassette. Then slide back the photo tray and lift it up. Note: Make sure the paper fits under the edge guide. 6 Slide the edge guides against the paper. 7 Keep the cassette flat as you insert it. 8 Extend the output tray and flip up the stopper. 2 Squeeze the edge guides and slide them out. Then insert paper with the glossy or printable side face-down.