Epson BrightLink 485Wi Operation Guide - EasyMP Monitor v4.52 - Page 42
Message, Remedy, Messages to inform that the projector has recovered from the error or
View all Epson BrightLink 485Wi manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 42 highlights
An e-mail notifying the operator of a problem/warning/status is issued 42 Message Remedy No signal No image signals are being received by the projector. Check the connection status and check that the power for the connected equipment is turned on. Auto Iris Error Stop using the projector, disconnect the power cable from the electrical outlet, and contact Epson. See your User's Guide for more information. Network error (TCP connection error) Check the following items. Check that the projector's power is turned on. Check that the LAN cable is connected. Check that Standby Mode is set to Communication On (or Network On) or Network Monitoring is set to On in the projector's configuration menu. See your User's Guide for more information. Network error Check that the projector has been correctly (ESC/VP.net connected to the network. See your User's Guide for communication error) more information. Network error Check the projector's Monitor Password. (Monitor Password authentication error) * When the projector has 2 lamps, the additional information, such as (Lamp 1) or (Ballast 1), is displayed after the message so that you can know which lamp has problems/warnings. Messages to inform that the projector has recovered from the error or warning statuses are sent.