Epson C11C616001 Product Information Guide - Page 7

Epson Stylus C68 The ink cartridge holder moves to the left, and the cartridge that needs to be replaced stops under the ink out mark. The power light flashes. 4. Open the cartridge cover. Squeeze the back tab of the empty/low cartridge as you lift it out of the printer. Don't take the used cartridge apart or try to refill it. Caution: To avoid damaging the printer, never move the print head by hand. Note: Don't hold down the ink button for more than 3 seconds, or the printer will start to clean the print head. If no cartridge needs to be replaced, the holder moves to the ink cartridge replacement position, shown on the next page. Go to step 5. 3. Press the ink button again. ❏ If more than one cartridge is empty, the next cartridge moves under the ink out mark. ❏ If all the empty cartridges have been identified, the print head moves right to the ink cartridge replacement position, shown below. Warning: If ink gets on your hands, wash them thoroughly with soap and water. If ink gets into your eyes, flush them immediately with water. 5. Before you remove the new cartridge from its package, shake it four or five times. Then remove it from the package. Caution: Do not remove or tear the label on the cartridge; otherwise ink will leak. Do not touch the green chip on the front of the cartridge. This can damage the ink cartridge. Don't touch the green part 6. Lower it into the holder. Push down gently until the cartridge is firmly seated and clicks into place. 7. If you need to replace other ink cartridges, repeat steps 5through 6 before continuing with step 8. 8. Close the cartridge cover. 6/05 Epson Stylus C68 - 7