Epson C31C412A8830 User Manual - Page 12

English 1. Insert the roll paper spacer so that the front edge goes through the notch and down to the shaft, as shown below. notch front edge roll paper spacer 2. Push the roll paper spacer until you feel it click onto the shaft. Note: Check that the roll paper spacer slides smoothly to the left and right. shaft inside edge of the spacer 3. Slide the roll paper spacer to the appropriate width, as shown above. You can use the measurement printed inside the printer, aligning the inside edge of the spacer with the desired measurement. Width note: When you want to set the roll paper width from 61 mm to 70 mm, break off by hand the two tabs of the spacer shown in tabs the illustration. (You can still also use widths from 38 mm to 60 mm with the spacer with the tabs broken off.) 8 TM-L90 User's Manual