Epson C42UX Start Here Card - Page 1

Epson C42UX - Stylus Color Inkjet Printer Manual

Page 1 highlights

EPSON Stylus® C42 Series SSttaarHrHtteerree 3 Press down firmly on the power button until the green power light comes on. Power button CAUTION: Use only the printer's power button to turn the printer on or off. 3 Load Ink 1 Open the cover and lift the ink cartridge clamps. CPD-13941 4022263-00 XXX 1 Unpack 1 Remove the tape and packing material from the printer. Remove the white insert 2 Peel off the tape beneath the cover and remove the insert. 3 Insert the paper support into the three slots on the back of the printer. 2 Power On 1 Find the power cord that came in the box and connect one end to the printer. 2 Plug the other end into a grounded electrical outlet. 2 1 continue 2 Unpack the ink cartridges that came with your printer and remove the yellow tape. 3 Insert both cartridges. Black Color Don't touch this part CAUTION: You must install both cartridges or the printer won't work. 4 Press down on the cartridge clamps until they click shut. 5 Press the maintenance button. The green power light flashes and you hear the printer charge its ink. 6 Close the printer cover. When the green power light stops flashing, charging is done. Maintenance button CAUTION: Never turn off the printer while the green power light is flashing. 4 Load Paper 1 Set some paper behind the tab on the right edge guide. Don't force it in. 2 Press in the locking tab on the left edge guide and slide it 1 against the paper. 3 Pull out the output tray. 2 3 NOTE: If you're using special EPSON paper, make sure you load the brighter, whiter side face up. 5 Attach the Cable 1 Connect the square end of the USB cable to your printer's USB port. 2 Connect the flat end of the cable to any available USB port on your computer. 6 Install the Software Follow the steps below to install the printer software on Windows® XP. To install software on Windows 98, Me, or 2000, see the booklet that came with your printer, Installing Software for Windows 98, Windows Me, and Windows 2000. For instructions on installing your Macintosh® software, see the back of this sheet. Windows XP 1 Turn on the computer. (Make sure your printer is still on.) 2 Wait for this screen to appear. NOTE: If you don't see the Found New Hardware screen, see "Problems?" on the back of this sheet. 3 Put the EPSON CD-ROM in your drive. 4 Wait while the files are copied to your computer. 5 Click Finish when you see this screen. 6 You see the license agreement. Read the agreement and click Agree. 7 You see this screen. Make sure you have paper in the printer, then click Print a Test Page to check that your printer is set up correctly. Click here 9 Click Install Printer Manual on the next screen to copy the ES C42 Manual icon to your desktop. (Then whenever you want to view the manual, just double-click the icon.) NOTE: You need Adobe® Acrobat® Reader® to view your manual. If you don't have it, click Install Adobe Acrobat Reader and follow the on-screen instructions. 10 When you're done, click Back to return to the Options Menu, then Exit to close it. 11 When you see the EPSON Product Registration screen, register your printer as instructed. Then remove your CD-ROM. You're ready to start printing! Follow the instructions below. Printing from Windows 1 Open a letter-size document in a program. 2 Click the File menu and select Print. You see a screen like this: 3 Click Properties or Preferences. You see this screen: Paper type Type of document 4 Select the type of document you're printing: Draft: For rough drafts on plain paper. Saves ink. Text: For text-only documents, like letters or reports. Text & Image: For documents that have both text and images, like newsletters. Photo: For photos or graphics, when you want good quality with faster printing. Photo RPM: For photos or graphics, when you need highest quality printing. 5 Load the right paper for your document. If you loaded special paper, select the correct paper type in the Type list. 6 Click OK. 7 After a moment, printing begins. You see this window showing your print job progress. Click to cancel printing Click to pause or resume printing Shows ink levels 8 After the test page prints, click View Printer Manual. continue For more information on printing, double-click the ES C42 Manual icon on your desktop to view the printer manual. Turn over

  • 1
  • 2

1
Find the power cord that came in the box and connect
one end to the printer.
2
Plug the other end into a
grounded electrical outlet.
1
Connect the
square end
of the USB cable to your printer’s
USB port.
2
Connect the
flat end
of the cable to any available
USB port on your computer.
EPSON Stylus
®
C42 Series
1
Open the cover and lift the
ink cartridge clamps.
2
Unpack the ink cartridges that
came with your printer and
remove the yellow tape.
3
Insert both cartridges.
4
Press down on the cartridge clamps until they click shut.
5
Press the
maintenance button.
The green
power light flashes and
you hear the printer charge its ink.
6
Close the printer cover. When
the green
power light stops
flashing, charging is done.
Black
Color
Maintenance
button
1
Set some paper behind the tab on the right edge guide.
Don
t force it in.
2
Press in the locking tab on the
left edge guide and slide it
against the paper.
3
Pull out the output tray.
3
1
2
Follow the steps below to install the printer software on Windows
®
XP. To install
software on Windows 98, Me, or 2000, see the booklet that came with your
printer,
Installing Software for Windows 98, Windows Me, and Windows 2000
.
For instructions on installing your Macintosh
®
software, see the back
of this sheet.
Windows XP
1
Turn on the computer. (Make sure your printer is still on.)
2
Wait for this screen to appear.
3
Put the EPSON CD-ROM in your drive.
4
Wait while the files are copied to
your computer.
5
Click
Finish
when you see this screen.
6
You see the license agreement. Read the agreement and click
Agree
.
7
You see this screen. Make sure you have paper in the printer,
then click
Print a Test Page
to check that your printer
is set up correctly.
8
After the test page prints, click
View Printer Manual
.
Printing from Windows
1
Open a letter-size document in a program.
2
Click the File menu and select
Print
. You see a screen like this:
3
Click
Properties
or
Preferences
. You see this screen:
4
Select the type of document you
re printing:
Draft:
For rough drafts on plain paper. Saves ink.
Text:
For text-only documents, like letters or reports.
Text & Image:
For documents that have both text and images,
like newsletters.
Photo:
For photos or graphics, when you want good quality
with faster printing.
Photo RPM:
For photos or graphics, when you need
highest quality printing.
5
Load the right paper for your document.
If you loaded special paper, select the
correct paper type in the Type list.
6
Click
OK
.
7
After a moment, printing begins. You see this window showing
your print job progress.
For more information on printing, double-click the
ES C42 Manual
icon
on your desktop to view the printer manual.
1
Remove the tape and packing material from the printer.
2
Peel off the tape beneath the
cover and remove the insert.
3
Insert the paper support
into the three slots on the
back of the printer.
Unpack
Attach the Cable
1
5
Load Ink
3
Load Paper
4
Install the
Software
6
Power On
2
continue
Turn over
Remove the
white insert
Start
Here
Start
Here
CAUTION: You must install both
cartridges or the printer won’t work.
CAUTION: Never turn off the printer
while the green
power light is
flashing.
1
2
continue
Power button
3
Press down firmly on the
power button
until the green
power light comes on.
CAUTION: Use only the printer
s
power button to turn the printer
on or off.
Paper type
Type of
document
Click to cancel printing
Click to pause or
resume printing
Shows ink levels
NOTE: If you
re using special EPSON
paper, make sure you load the
brighter, whiter side face up.
NOTE: If you don
t see the Found New Hardware screen,
see
Problems?
on the back of this sheet.
Don
t touch this part
9
Click
Install Printer Manual
on the next screen to copy the
ES C42
Manual
icon to your desktop. (Then whenever you want to view the
manual, just double-click the icon.)
10
When you
re done, click
Back
to return to the Options Menu,
then
Exit
to close it.
11
When you see the EPSON Product Registration screen, register your
printer as instructed. Then remove your CD-ROM.
You
re ready to start printing! Follow the instructions below.
Click here
NOTE: You need Adobe
®
Acrobat
®
Reader
®
to view your
manual. If you don
t have it, click
Install Adobe Acrobat
Reader
and follow the on-screen instructions.
CPD-13941
4022263-00
XXX