Epson CX5000 Product Information Guide - Page 15

6. Squeeze the tab at the back of the cartridge and lift it straight out. Dispose of it carefully. Do not take the used cartridge apart or try to refill it. Epson Stylus CX5000 Series 9. Place the new ink cartridge into the cartridge holder and push it down until it clicks into place. Warning: If ink gets on your hands, wash them thoroughly with soap and water. If ink gets into your eyes, flush them immediately with water. 7. Before you open the new ink cartridge package, shake it four or five times. Then remove it from the package. 10. Replace any other cartridges that need to be replaced. 11. Close the ink cartridge cover and press it until it clicks into place. 12. Close the scanner. Caution: Do not touch the green chip on the front of the cartridge. This can damage the ink cartridge. 8. Remove the yellow tape from the bottom of the ink cartridge. Caution: If you do not remove the yellow tape before installing the ink cartridge, print quality may decline or you may not be able to print. Do not remove any other seals from the cartridges. 13. Press the B ink button. The CX5000 Series begins charging ink and the On light starts flashing. This takes about one minute. When it's finished, the On light stops flashing and remains on, and the B ink light goes out. Caution: Never turn off the CX5000 Series while the On light is flashing or you'll waste ink. Note: If the B ink light stays on (not flashing), the ink cartridge may not be installed correctly. Press the B ink button again and reinstall the ink cartridge until it clicks into place. 6/06 15