Epson EMP 800 User Guide - Page 84

Troubleshooting Indicator status red orange Projector status High-speed cooling in progress orange Lamp will soon need to be replaced. orange Standby condition Problem and remedy (This is not an abnormality, but if the temperature rises too high again, projection will stop automatically.) • Set the projector up in a place which is well-ventilated, and so that the air inlet and exhaust vents are clear. • Clean the air filter. Have a new replacement lamp ready. The lamp service life can become shorter than normal as a result of the usage conditions, and so the lamp should be replaced as soon as possible. * The appearance of the operation indicator at this time will vary depending on the status of the projector. (No abnormality) Projection starts when the [Power] button is pressed. Reference page P.18 P.92 P.94 P.37 green Warm-up in (No abnormality) P.37 progress Wait for a short while. The indicator will stop flashing and light with a green color. green Projecting in (No abnormality) P.37 progress orange Cool-down in (No abnormality) P.39 progress • Wait for a short while. The cool-down (lamp cooling operation) period lasts for about 2 minutes. The actual time will vary depending on the external air temperature. • The [Power] button will not operate during the cool-down period. When cool-down is complete, the indicator will stop flashing and light orange. You can then use the [Power] button. Tip : • If the projector is not operating properly even though the indicators are all showing normal, refer to "When the Indicators Provide No Help" on the following page. • If an indicator is showing a status which does not appear in the previous tables, contact your dealer or the nearest address provided on page 11 of the Safety Instructions/World-Wide Warranty Teams. 82