Epson ET-2500 User Manual - Page 2
Load paper - printer
View all Epson ET-2500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 2 highlights
5 Carefully seal the bottle using the reverse side of the bottle tip for proper disposal. 6 Replace the ink tank cap securely. 7 Repeat the previous steps for the remaining bottles. 8 Close the ink tank unit cover. 11 Press the button for 3 seconds until the power light starts flashing, to begin charging the ink. Ink charging takes approximately 20 minutes. Ink charging is complete when the power light stops flashing. 3 seconds 20 minutes Note: The ink bottles included with the printer are designed for printer setup and not for resale. After some ink is used for charging, the rest is available for printing. Caution: Do not turn off the product or load paper while the product is charging or you'll waste ink. 3 Load paper 1 Make sure the product is not charging. Then flip the feeder guard forward, raise the paper support, and tilt it backwards slightly. 9 Connect the power cord to the back of the product and to an electrical outlet. 2 Slide the edge guide to the left. Caution: Do not connect to your computer yet. 10 Raise the control panel and turn on the product. Wait for the power light to stop flashing. 3 Load paper, glossy or printable side up and short edge first, against the right side of the rear paper feed slot. 4 Slide the edge guide against the paper, but not too tightly, and flip the feeder guard back. Note: If all the product lights are flashing, turn off the product and check that no protective material has been left inside the product. Caution: Do not lower the control panel without first squeezing the release bar underneath or you may damage the product.