Epson ET-2600 Start Here - Installation Guide - Page 3

3 Load paper, glossy or printable side up and short edge first, against the right side of the rear paper feed slot. 4 Slide the edge guide against the paper, but not too tightly, and flip the feeder guard back. 5 Pull out the output tray and raise the paper stopper. 4 Install software Note: If your computer does not have a CD/DVD drive or you are using a Mac, an Internet connection is required to obtain the product software. 1 Make sure the product is NOT CONNECTED to your computer. Windows®: If you see a Found New Hardware screen, click Cancel and disconnect the USB cable. 2 Insert the product CD or download and run your product's software package: www.epson.com/support/et2600 (U.S.) or www.epson.ca/support/et2600 (Canada) 3 Follow the instructions on the screen to run the setup program. 4 When you see the Select Your Connection screen, select one of the following: • Wireless connection In most cases, the software installer automatically attempts to set up your wireless connection. If setup is unsuccessful, you may need to enter your network name (SSID) and password. • Direct USB connection Make sure you have a USB cable (not included). Mobile printing options Connect wirelessly from your smartphone, tablet, or computer. Print documents and photos from across the room or around the world. See your online User's Guide for instruction or learn more at www.epsonconnect.com. Any problems? Network setup was unsuccessful • Make sure you select the right network name (SSID). • Restart your router (turn it off and then on), then try to connect to it again. • The printer can only connect to a network that supports 2.4 GHz connections. If your router offers both 2.4 GHz and 5 GHz connections, make sure the 2.4 GHz network is enabled. • If you see a firewall alert message, click Unblock or Allow to let setup continue. • If your network has security enabled, make sure you enter your network password (WEP key or WPA passphrase) correctly. Be sure to enter your password in the correct case. There are lines or incorrect colors in my printouts Run a nozzle check to see if any of the print head nozzles are clogged. Then clean the print head, if necessary. See the online User's Guide for more information. Setup is unable to find my product after connecting it with a USB cable Make sure the product is on and securely connected as shown: