Epson ET-2720 Start Here - Installation Guide - Page 2
Load paper - ink refill
View all Epson ET-2720 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 2 highlights
6 Close the black ink tank cap. 7 Repeat the previous steps for the other colors. 13 Press the start button to start ink charging. Note: Ink charging takes about 10 minutes. When the power light stops flashing, ink charging is complete. Once initial setup of the printer is complete, you can top off the ink tanks with any remaining ink. See the online User's Guide for instructions. Caution: Do not unplug or turn off the product, or open the inner cover while the product is charging or you'll waste ink. Caution: After setup, periodically inspect the ink levels to ensure they do not fall below the lower lines. Prolonged use when any level is lower than the line could damage the product. See the online User's Guide for refilling instructions. 8 Close the ink tank cover. 9 Connect the power cord to the back of the product and to an electrical outlet. Caution: Do not connect to your computer yet. 10 Raise the control panel, then press the power button to turn on the product. The power light flashes. 14 Press the OK button to proceed with initial setup. 15 Follow the on-screen instructions to adjust the print quality of your product. Note: • You need to load paper before you can adjust the print quality. See "Load paper" below for details. • Select Adjust Later if you want to adjust the print quality later. For more information, see the online User's Guide. 3 Load paper See the online User's Guide for information about loading capacity, available paper types and sizes, and loading envelopes. 1 Make sure the product is not charging ink. Open the feeder guard then raise the paper support and tilt it backwards slightly. 11 Select your language. Note: You can change this setting later using the product's control panel. For more information, see the online User's Guide. 12 When instructed to see the Start Here sheet, press and hold the help button for 5 seconds. 2 Slide the edge guides all the way out. 3 Load paper, glossy or printable side up and short edge first, in the middle of the rear paper feed slot. Note: Make sure the paper is under the mark inside the edge guides.