Epson ET-2750 Start Here - Installation Guide - Page 2

5 When the ink tank is full, remove the ink bottle and securely close the ink tank cap. Place the remaining ink aside; you will need it later. 12 When the message to start initialization appears on the LCD screen, press the start button to start charging the ink. Ink charging takes approximately 10 minutes. A message appears when ink charging is complete. Press the OK button to continue. Note: Replace the bottle cap and tighten it. 6 Repeat the previous steps for the other colors. 7 Close the ink tank cover and then the scanner unit. 8 Connect the power cord to the back of the product and to an electrical outlet. Caution: Do not connect to your computer yet. 9 Raise the control panel, then press the power button to turn on the product. Note: If an error message appears, turn off the product and check that no protective material has been left inside the product. 10 Press or to select your language on the LCD screen, then press the OK button. Follow steps 11 and 12 to continue ink charging. Note: You can change this setting later using the product's control panel. For more information, see the online User's Guide. 11 When the message to see the Start Here sheet appears on the LCD screen, press the OK button. On the next screen, press and hold the help button for 3 seconds. Note: After some ink is used for charging, the rest is available for printing. Caution: Do not turn off the product, raise the scanner unit, or load paper while the product is charging or you'll waste ink. 13 To complete filling the ink tanks, repeat steps 1 through 6 using the remaining ink in the bottles. Note: Replace the bottle cap before disposing of the bottles. 14 Close the ink tank cover and scanner unit. 15 Select Maintenance > Reset Ink Levels, then follow the on-screen instructions to reset the ink levels. 16 Follow the on-screen instructions to adjust the print quality. Press the OK button to continue. Note: You can change these settings later using the product's control panel. For more information, see the online User's Guide. 3 Load paper See the online User's Guide for information about loading capacity and available paper types and sizes. 1 Make sure the product is not charging. Then flip the feeder guard forward, raise the paper support, and tilt it backwards slightly. 2 Slide the edge guides all the way out.