Epson ET-2750U for ReadyPrint Users Guide - Page 176
Solving Setup Problems, Noise After Filling the Ink, Software Installation Problems
View all Epson ET-2750U for ReadyPrint manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 176 highlights
4. Select one of these options: • Network Settings: Resets all network settings. • All except Network: Resets all settings except network settings. • All Settings: Resets all settings. You see a confirmation screen. 5. Press the OK button to reset the selected settings. (Press the stop button if you want to cancel the operation.) Parent topic: Solving Problems Solving Setup Problems Check these sections if you have problems while setting up your product. Noise After Filling the Ink Software Installation Problems Control Panel Setup Problems Parent topic: Solving Problems Noise After Filling the Ink If you hear noises from your product after filling the ink tanks with ink, check these explanations: • The first time you fill the tanks with ink, the product must charge its print head. Wait until charging finishes before you turn off the product, or it may charge improperly and use excess ink the next time you turn it on. Your product is finished charging the print head when the power light stops flashing. • If the product's print head stops moving or making noise, and the charging process has not finished after approximately 20 minutes, turn off your product. Turn it back on and check to see if charging is still in progress. If it is still in progress, contact Epson for help. Parent topic: Solving Setup Problems Software Installation Problems If you have problems while installing your product software, try these solutions: • Make sure your product is turned on and any necessary cables are securely connected at both ends. If you still have problems installing software, disconnect the cable and carefully follow the instructions on the Start Here sheet. Also make sure your system meets the requirements for your operating system. 176