Epson ET-3600 Start Here - Installation Guide - Page 1

ET-3600 Start Here Read these instructions before using your product. Nota para hispanohablantes/Note for Spanish speakers: Para obtener instrucciones de configuración en español, consulte la Guía de instalación en www.epson.com/support/et3600sp (requiere una conexión a Internet). 1 Unpack French control panel stickers 3 Lower the scanner unit. 2 Fill ink tanks Note: This product requires careful handling of ink. Wear disposable gloves and place a sheet of paper or plastic under the ink tank when you fill or refill the ink tanks, as ink may splatter. If ink spills, wipe it off immediately with a damp towel to avoid permanent stains. If ink gets on your clothes or belongings, it may not come off. Warning: Keep the ink bottles out of the reach of children and do not drink the ink. 1 Open the ink tank unit cover, then remove the cap for the black ink tank and attach it to its holder. Note: • Your product includes 4 Initial ink bottles that are designed for product setup and 4 additional bottles (1 black bottle and 3 smaller color Bonus bottles) for refilling. These bottles are not for resale. • Do not open the ink bottles until you are ready to fill the ink tanks. The ink bottles are vacuum packed to maintain reliability. 1 R emove all protective materials from the product. 2 Unpack the black Initial ink bottle. 2 Lift up the scanner unit and remove all protective materials from inside the product. 3 Snap the bottle tip off, then remove the bottle cap. Carefully remove the protective seal (avoid touching the ink underneath the seal), then close the bottle cap tightly. Caution: Be sure to close the bottle cap tightly, or ink may leak. 4 Fill the tank using all of the ink in the bottle. Caution: Do not touch the translucent part or ink tubes. Note: Refer to the color-coded sticker above the ink tank unit to identify the color of each tank. Caution: Be sure to fill each tank with the correct color.