Epson ET-4500 User Manual
Epson ET-4500 Manual
 |
View all Epson ET-4500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Epson ET-4500 manual content summary:
- Epson ET-4500 | User Manual - Page 1
ET-4500 Start Here Read these instructions before using your product. Note for Spanish speakers/Nota para hispanohablantes: Para obtener instrucciones de configuración en español, consulte la Guía de instalación en epson.com/support/et4500sp (requiere una conexión a Internet). 1 Unpack French - Epson ET-4500 | User Manual - Page 2
with the printer are designed for printer setup and not for resale. After some ink is used for charging, the rest is available for printing. Caution: Do not turn off the product, raise the scanner unit, or load paper while the product is charging or you'll waste ink. 3 Load paper 1 Make sure - Epson ET-4500 | User Manual - Page 3
must be entered in the correct case. There are lines or incorrect colors in my printouts. Run a nozzle check to see if any of the print head nozzles are clogged. Then clean the print head, if necessary. See the online User's Guide for more information. The product's screen is dark. Make sure your - Epson ET-4500 | User Manual - Page 4
You can also purchase supplies from an Epson authorized reseller. Call 800-GO-EPSON (800-463-7766). ET-4500 refill inks Color Black Cyan Magenta Yellow Part number 664 664 664 664 EPSON is a registered trademark, Epson Connect is a trademark, and EPSON Exceed Your Vision is a registered logomark
-
1 -
2 -
3 -
4
 |
 |
Start Here
2
Fill ink tanks
Note:
This product requires careful handling of ink. Wear disposable
gloves and place a sheet of paper under the ink tank unit when you
fill or refill the ink tanks, as ink may splatter. If ink spills, wipe it off
immediately with a damp towel to avoid permanent stains. If ink gets on
your clothes or belongings, it may not come off.
Warning:
Keep the ink bottles out of the reach of children and do not
drink the ink.
1
Open the ink tank unit cover, then remove the cap for the
cyan ink tank and attach it to its holder.
1
2
3
2
Unpack the cyan ink bottle.
3
Snap the bottle tip off, then remove the bottle cap.
Carefully remove the protective seal (avoid touching the ink
underneath the seal), then close the bottle cap tightly.
Caution:
Be sure to close the bottle cap tightly, or ink may leak.
4
Fill the tank using all of the ink in the bottle.
Note:
Refer to the color coded sticker above the ink tank unit to
identify the color of each tank.
Caution:
Be sure to fill each tank with the correct ink color.
5
Carefully seal the bottle using the reverse side of the bottle
tip for proper disposal.
ET-4500
Read these instructions before using your product.
Note for Spanish speakers/Nota para hispanohablantes:
Para
obtener instrucciones de configuración en español, consulte la
Guía de
instalación
en
epson.com/support/et4500sp
(requiere una conexión a
Internet).
1
Unpack
French
control
panel
sticker
Note:
Do not open the ink bottles until you are ready to fill the ink
tanks. The ink bottles are vacuum packed to maintain reliability.
1
Remove all protective materials from the product.
2
Lift up the scanner unit and remove all protective materials
from inside the product.
1
2
Caution:
Do not touch the flat white cable or the ink tubes and
their translucent cover.
3
Lower the scanner unit.