Epson ET-4500 User Manual - Page 2
Load paper - user manual
View all Epson ET-4500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 2 highlights
6 Replace the ink tank cap securely. 12 Press one of the Start buttons to start charging the ink. Ink charging takes approximately 20 minutes. Ink charging is complete when the power light stops flashing. 7 Repeat the previous steps for the remaining bottles. 8 Close the ink tank unit cover. 9 Connect the power cord to the back of the product and to an electrical outlet. 20 minutes Note: The ink bottles included with the printer are designed for printer setup and not for resale. After some ink is used for charging, the rest is available for printing. Caution: Do not turn off the product, raise the scanner unit, or load paper while the product is charging or you'll waste ink. 3 Load paper 1 Make sure the product is not charging. Then flip the feeder guard forward, raise the paper support, and tilt it backwards slightly. 3 2 1 2 Slide the edge guide to the left. Caution: Do not connect to your computer yet. 10 Turn on the product. Select your language, country, date, and time. 3 Load paper, glossy or printable side up and short edge first, against the right side of the rear paper feed slot. Note: • You can change these settings later using the product's control panel. For more information, see the online User's Guide. • If an error message appears, turn off the product and check that no protective material has been left inside the product. 11 When the message to see the setup manual is displayed on the LCD screen, press and hold the OK button for 3 seconds. 4 Slide the edge guide against the paper, but not too tightly, and flip the feeder guard back. 2 1 3 seconds