Epson ET-4550 User Manual
Epson ET-4550 Manual
 |
View all Epson ET-4550 manuals
Add to My Manuals
Save this manual to your list of manuals |
Epson ET-4550 manual content summary:
- Epson ET-4550 | User Manual - Page 1
kit Note: • Your product includes 4 Initial bottles that are designed for product setup and 4 additional bottles (1 black bottle and 3 smaller color Bonus bottles) for refilling. • Do not open the ink bottles until you are ready to fill the ink tanks. The ink bottles are vacuum packed to maintain - Epson ET-4550 | User Manual - Page 2
Initial bottles. 8 Close the ink tank unit cover. 9 Connect the power cord to the back of the product and to an electrical outlet. 20 minutes Note: After some ink is used for charging, the rest is available for printing. Caution: Do not turn off the product, raise the scanner unit, or load paper - Epson ET-4550 | User Manual - Page 3
key or WPA passphrase) correctly. Passwords must be entered in the correct case. There are lines or incorrect colors in my printouts. Run a nozzle check to see if any of the print head nozzles are clogged. Then clean the print head, if necessary. See the online User's Guide for more information. The - Epson ET-4550 | User Manual - Page 4
inks and papers to get good results. For the right supplies at the right time, you can purchase them at epson.com/ink3 (U.S. sales) or epson.ca (Canadian sales). You can also purchase supplies from an Epson authorized reseller. Call 800-GO-EPSON (800-463-7766). ET-4550 refill inks Color Black
-
1 -
2 -
3 -
4
 |
 |
Start Here
Read these instructions before using your product.
Note for Spanish speakers/Nota para hispanohablantes:
Para
obtener instrucciones de configuración en español, consulte la
Guía de
instalación
en
epson.com/support/et4550sp
(requiere una conexión a
Internet).
1
Unpack
French control
panel sticker
Transportation
kit
Note:
• Your product includes 4
Initial
bottles that are designed for product
setup and 4 additional bottles (1 black bottle and 3 smaller color
Bonus
bottles) for refilling.
• Do not open the ink bottles until you are ready to fill the ink tanks.
The ink bottles are vacuum packed to maintain reliability.
1
Remove all protective materials from the product.
2
Lift up the scanner unit and remove all protective materials
from inside the product.
Caution:
Do not touch the translucent part or ink tubes.
3
Lower the scanner unit.
2
Fill ink tanks
Note:
This product requires careful handling of ink. Wear disposable
gloves and place a sheet of paper under the ink tank when you
fill or refill the ink tanks, as ink may splatter. If ink spills, wipe it off
immediately with a damp towel to avoid permanent stains. If ink gets on
your clothes or belongings, it may not come off.
Warning:
Keep the ink bottles out of the reach of children and do not
drink the ink.
1
Open the ink tank unit cover, then remove the cap for the
black ink tank and attach it to its holder.
2
Unpack the black
Initial
ink bottle.
3
Snap the bottle tip off, then remove the bottle cap.
Carefully remove the protective seal (avoid touching the ink
underneath the seal), then close the bottle cap tightly.
Caution:
Be sure to close the bottle cap tightly, or ink may leak.
4
Fill the tank using all of the ink in the bottle.
Note:
Refer to the color coded sticker above the ink tank unit to
identify the color of each tank.
Caution:
Be sure to fill each tank with the correct ink color.
ET-4550