Epson FX-850 Product Support Bulletin(s) - Page 3
Informa
View all Epson FX-850 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 3 highlights
EPSON EPSON AMERICA, INC. INFORMA Product Support Bulletin Subject: Tractor Pin Alignment Date: 5/15/89 Page: 1 of 1 PSB No: P - 0044 Originator: RP bd The purpose of this bulletin is to insure the proper installation and alignment of the FX-850/1050 and LQ- 850/1050 push tractor assemblies. There are two possible ways to install the tractor frame on the push tractor assembly. If the frame is installed incorrectly, the tractor belt pins on the two tractors will not be aligned, and the resulting printout appears to be slanted on the page, or the perforated edge will be tom. This is caused by the marks on the tractor shaft holders being 180 degrees 'out of phase.' When assembling a tractor, there are two grooves in the shaft, and two tabs on the tractor shaft holder. lf the pins on both tractor belts are not aligned, it will be necessary to disassemble the tractor, and rotate one tractor shaft holder 180 degrees, to bring it back into alignment with the other shaft holder. Alignment can be verified by examining the marks in the shaft holders, which will both be in the forward position when properly aligned, as shown in Figure 4- 51 below. Figure 4-51. Tractor Assembly Phases