Epson LQ-850X Product Information Guide - Page 8

Installation/Support Tips - lq 850 printer drivers

Page 8 highlights

NEW LQ-850/1050+ DOT-MATRIX PRINTER 1 Installation/Support Tips 1 Short Tear Off To activate the short tear-off feature on the printer, first turn DIP switch 2-7 to the on position. To control it through the software, send a form feed command at the end of each page. After sending a form feed, do not send it any more data for a 3second interval/ Single-Sheet Loading When loading single sheets, make sure that the paper lever is set to single sheets, not tractor paper. The paper can be loaded manually or via auto load. Before attempting to load in the paper, wait for the platen to lock in place after changing the paper lever. Setting up the Page Length The page length has to be adjusted for using single sheets and for using tractor paper. When your software you asks you to set up the number of lines/page, single sheets require a shorter page length than does tractor paper. Set the page length to 61 lines for single sheets (also when using the cut-sheet feeder) and 66 lines for tractor paper. Software The type of printer installed on your system must be identified for each software package. This is usually done through a setup menu. If the LQ-850/1050+ is not listed in the software package, any Epson 24-pin driver will be compatible. DIP Switch Settings The default settings will usually work for most applications, but they should be checked before using the printer. This will avoid unexpected results. NEW LQ-850/1050+-8 12/31/90 24-Pin Printers

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8

NEW LQ-850/1050+ DOT-MATRIX PRINTER
1
Installation/Support Tips
1
Short Tear Off
To activate the short tear-off feature on the printer, first turn DIP
switch 2-7 to the on position. To control it through the software,
send a form feed command at the end of each page. After
sending a form feed, do not send it any more data for a 3-
second interval/
Single-Sheet Loading
When loading single sheets, make sure that the paper lever is
set to single sheets, not tractor paper. The paper can be loaded
manually or via auto load.
Before attempting to load in the
paper, wait for the platen to lock in place after changing the
paper lever.
Setting up the Page Length
The page length has to be adjusted for using single sheets and
for using tractor paper. When your software you asks you to set
up the number of lines/page, single sheets require a shorter
page length than does tractor paper. Set the page length to 61
lines for single sheets (also when using the cut-sheet feeder)
and 66 lines for tractor paper.
Software
The type of printer installed on your system must be identified
for each software package. This is usually done through a setup
menu. If the LQ-850/1050+ is not listed in the software
package, any Epson 24-pin driver will be compatible.
DIP Switch Settings
The default settings will usually work for most applications, but
they should be checked before using the printer. This will avoid
unexpected results.
NEW LQ-850/1050+-8
12/31/90
24-Pin Printers