Epson MovieMate 55 Quick Guide - Page 18

operating instructions, or if it exhibits a distinct change in performance, indicating - + noise

Page 18 highlights

■ The lamp in this projector is under high internal pressure and may make a loud noise if it breaks. If it breaks, ventilate the room to prevent mercury gas inside the lamp from being inhaled or coming into contact with the eyes or mouth. ■ Do not bring your face close to the projector while it is in use, to prevent inhaling or contact with the gases inside the lamp if it breaks. ■ If the lamp breaks and gas from the lamp or fragments of broken glass are inhaled or get into the eyes or mouth, or if any other ill effects are noticed, immediately seek medical advice. ■ Use the type of power source indicated on the projector. If you're not sure of the power available, consult the power company. ■ If you use the projector in a country other than where you purchased it, use the correct power cord for that country. ■ Place the projector near a wall outlet where the plug can be easily unplugged. ■ Don't place the projector where the cord can be walked on. This may result in fraying or damage to the plug. ■ Don't insert the plug into an outlet with dust present, and insert the plug firmly into the outlet. Failure to do so could result in sparks or fire. ■ Don't handle the plug with wet hands. ■ Don't overload wall outlets, extension cords, or integral convenience receptacles. This can cause fire or electric shock. ■ Unplug the projector from the wall outlet and refer servicing to qualified service personnel under the following conditions: when the power cord or plug is damaged or frayed; if liquid has been spilled into the projector, or if it has been exposed to rain, water, or excessive humidity; if it doesn't operate normally when you follow the operating instructions, or if it exhibits a distinct change in performance, indicating a need for service; if it has been dropped or the housing has been damaged. ■ If there is an electrical storm, do not touch the power plug, otherwise you may receive an electric shock. ■ Keep the projector unplugged during electrical storms and when the projector is not in use for extended periods. ■ Keep the batteries for the remote control out of the reach of children. Batteries are choking hazards and can be very dangerous if swallowed. If they are swallowed, seek medical attention immediately. ■ Replace the batteries as soon as they run out. ■ Do not expose batteries to heat or flame. ■ Dispose of used batteries according to local regulations. ■ Remove the batteries if you won't be using the projector for an extended period. 18 Notices

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24

18
Notices
The lamp in this projector is under high internal pressure and may make a loud noise
if it breaks. If it breaks, ventilate the room to prevent mercury gas inside the lamp
from being inhaled or coming into contact with the eyes or mouth.
Do not bring your face close to the projector while it is in use, to prevent inhaling or
contact with the gases inside the lamp if it breaks.
If the lamp breaks and gas from the lamp or fragments of broken glass are inhaled or
get into the eyes or mouth, or if any other ill effects are noticed, immediately seek
medical advice.
Use the type of power source indicated on the projector. If you’re not sure of the
power available, consult the power company.
If you use the projector in a country other than where you purchased it, use the
correct power cord for that country.
Place the projector near a wall outlet where the plug can be easily unplugged.
Don’t place the projector where the cord can be walked on. This may result in fraying
or damage to the plug.
Don’t insert the plug into an outlet with dust present, and insert the plug firmly into
the outlet. Failure to do so could result in sparks or fire.
Don’t handle the plug with wet hands.
Don’t overload wall outlets, extension cords, or integral convenience receptacles. This
can cause fire or electric shock.
Unplug the projector from the wall outlet and refer servicing to qualified service
personnel under the following conditions: when the power cord or plug is damaged or
frayed; if liquid has been spilled into the projector, or if it has been exposed to rain,
water, or excessive humidity; if it doesn’t operate normally when you follow the
operating instructions, or if it exhibits a distinct change in performance, indicating a
need for service; if it has been dropped or the housing has been damaged.
If there is an electrical storm, do not touch the power plug, otherwise you may receive
an electric shock.
Keep the projector unplugged during electrical storms and when the projector is not
in use for extended periods.
Keep the batteries for the remote control out of the reach of children. Batteries are
choking hazards and can be very dangerous if swallowed. If they are swallowed, seek
medical attention immediately.
Replace the batteries as soon as they run out.
Do not expose batteries to heat or flame.
Dispose of used batteries according to local regulations.
Remove the batteries if you won’t be using the projector for an extended period.