Epson PM-400 User Manual - Page 2
Load paper - printer
View all Epson PM-400 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 2 highlights
3 Open the inner cover. 4 Load paper 1 Slide the edge guide to the right. Caution: Do not touch the flat white cable. 4 Hold the cartridge with the green chip facing towards you and insert the cartridge at an angle as shown. Then press the ink cartridge down until it clicks into place. 2 Load one of the included 4 x 6-inch sheets, glossy or printable side up and short edge first. Caution: Make sure to insert the ink cartridge in the correct direction or you may damage the product. 5 Close the inner cover. 6 Press the button to start charging the ink. 3 Slide the edge guide against the paper, but not too tightly. 4 Select Change on the LCD screen and press the OK button. 5 Select 4x6in and press the OK button. 6 Select Prem. Glossy and press the OK button. 7 Press the OK button again to confirm the paper settings. Ink charging takes approximately 4 minutes. Ink charging is complete when you see the home screen displayed on the LCD screen. Caution: Don't turn off the product or open the inner cover while it is charging or you'll waste ink. Note: • The printer is designed for use with Epson® cartridges only, not third-party cartridges or ink. • The cartridge included with the printer is designed for printer set up and not for resale. After some ink is used for charging, the rest is available for printing.