Epson PictureMate PM-400 User Manual - Page 2

Load paper

Get Epson PictureMate PM-400 PDF manuals and user guides View all Epson PictureMate PM-400 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 2 highlights

3 Open the inner cover. 4 Load paper 1 Slide the edge guide to the right. Caution: Do not touch the flat white cable. 4 Hold the cartridge with the green chip facing towards you and insert the cartridge at an angle as shown. Then press the ink cartridge down until it clicks into place. 2 Load one of the included 4 x 6-inch sheets, glossy or printable side up and short edge first. Caution: Make sure to insert the ink cartridge in the correct direction or you may damage the product. 5 Close the inner cover. 6 Press the button to start charging the ink. 3 Slide the edge guide against the paper, but not too tightly. 4 Select Change on the LCD screen and press the OK button. 5 Select 4x6in and press the OK button. 6 Select Prem. Glossy and press the OK button. 7 Press the OK button again to confirm the paper settings. Ink charging takes approximately 4 minutes. Ink charging is complete when you see the home screen displayed on the LCD screen. Caution: Don't turn off the product or open the inner cover while it is charging or you'll waste ink. Note: • The printer is designed for use with Epson® cartridges only, not third-party cartridges or ink. • The cartridge included with the printer is designed for printer set up and not for resale. After some ink is used for charging, the rest is available for printing.

  • 1
  • 2
  • 3
  • 4
4
Load paper
1
Slide the edge guide to the right.
2
Load one of the included 4 x 6-inch sheets, glossy or
printable side up and short edge first.
3
Slide the edge guide against the paper, but not too tightly.
4
Select
Change
on the LCD screen and press the
OK
button.
5
Select
4x6in
and press the
OK
button.
6
Select
Prem. Glossy
and press the
OK
button.
7
Press the
OK
button again to confirm the paper settings.
3
Open the inner cover.
Caution:
Do not touch the flat white cable.
4
Hold the cartridge with the green chip facing towards you
and insert the cartridge at an angle as shown. Then press
the ink cartridge down until it clicks into place.
Caution:
Make sure to insert the ink cartridge in the correct
direction or you may damage the product.
5
Close the inner cover.
6
Press the
button to start charging the ink.
Ink charging takes approximately 4 minutes. Ink charging
is complete when you see the home screen displayed on
the LCD screen.
Caution:
Don’t turn off the product or open the inner cover while
it is charging or you’ll waste ink.
Note:
•
The printer is designed for use with Epson
®
cartridges only, not
third-party cartridges or ink.
•
The cartridge included with the printer is designed for printer
set up and not for resale. After some ink is used for charging,
the rest is available for printing.