Epson PowerLite 1775W Quick Setup - Page 3

4 Insert the wireless LAN module into the port. 12 Select the Wireless LAN menu and press Enter. 5 Replace the cover and secure it using the screw. 6 Plug in and turn on the projector. 7 To configure your projector for your wireless network, do one of the following: • If you're using the optional Quick Wireless Connection USB key (included with the PowerLite 1775W), insert it into the projector's USB TypeA port, wait for the displayed message, remove the key, and connect it to a USB port on your computer. Follow the on-screen instructions to install the driver, then run your presentation. For details, see the User's Guide on your projector CD. • If you're not using the key, continue with these steps. 8 Press the Menu button on the remote control, select the Network menu, and press Enter. 9 Choose Network Configuration and press Enter. 10 Select the Basic menu and press Enter. 13 Select the Connection Mode setting and choose one of these options: • Quick to connect the projector to one computer on the network • Advanced to connect the projector to multiple computers on the network 14 If you selected Quick connection mode, select the Channel setting for your wireless network and turn on the SSID Auto Setting setting. 15 Select the type of wireless network you are using as the Wireless LAN Sys. setting. 16 If you selected Advanced connection mode, enter your network SSID (up to 32 characters) as the SSID setting. 17 If your network assigns addresses automatically, select IP Settings and turn on the DHCP setting. If not, turn off the DHCP setting and enter the projector's IP Address, Subnet Mask, and Gateway Address, as needed. 18 To prevent the SSID and IP address from appearing on the network standby screen, set the SSID Display and/or IP Address Display settings to Off. 19 See the next section for additional instructions. Install network software Install the EasyMP® Network Projection software on each computer that will project over the network. Use the CD labeled Epson Projector Software for Meeting & Presentation to install the program. For instructions on installing and using your network software, see the EasyMP Network Projection Operation Guide on your projector CD. This guide is installed along with your projector User's Guide. 11 Select the Projector Name setting and enter a name (up to 16 characters long) to identify your projector over the network. Use the displayed keyboard to enter characters. Press the arrow buttons on the remote control to highlight the characters and press Enter to select them. Note: See the User's Guide on the projector CD for information on adding passwords.