Epson PowerLite 1825 Start Here - Page 1

PowerLite® 1825 Quick Setup Before using the projector, make sure you read the safety instructions in the User´s Guide on your projector CD. 1 Turn On Your Equipment 1 Connect the power cord to the back of the projector and plug the other end into an electrical outlet. 2 Turn the focus ring to sharpen the image. Turn the zoom ring to reduce or enlarge the image. Focus Zoom 3 If your image looks like , , , or , press the Quick Setup button on the projector and follow the on-screen instructions. 2 Open the A/V Mute slide (lens cover). Make sure the slide is opened completely. 3 Remove the battery cover on the remote control. Locate the two AAA batteries that came with the projector and insert them. Then replace the battery cover. 4 To turn the projector on, press the Power button on the projector or the remote control. The projector beeps once, and the projector's Power light flashes green and then stays on. Power light Power button To shut down the projector: 1. Press the Power button twice. 2. When the orange light stops flashing and the projector beeps, you can unplug the projector. 3 C hoose a Presentation Method How do you want to get images to the projector? • To connect to a notebook, see "If connecting to a notebook" below. • To project over a wireless network, see "If projecting wirelessly" on the back of this sheet. Computer cable Y ou must have installed the projector's EasyMP® software and configured your projector and computer before you can project wirelessly. See your User's Guide for instructions. • To give a presentation stored on a CompactFlash® memory card, flash drive, digital camera, or other USB storage device, see Chapter 5 in your User's Guide. • To connect to your notebook using the included USB cable, see your User's Guide. If connecting to a notebook... 1 Turn on the projector and adjust the image as described in sections 1 and 2 on this sheet. 2 Locate the computer cable that came with the projector. Connect one end to the projector's blue Computer1 port. Connect the other end to your notebook's video-out port or monitor port. 2 Adjust the Image 1 To raise the image, press the foot release button for the front adjustable foot and lift the front. Release the button to lock the foot in position. *411303300* *411303300* 3 Press the Source Search button on the projector or the Search button on the remote control until your computer image is displayed. NOTE: If your notebook has a DVI connector, you need to use an optional DVI-to-VGA adapter with the included computer cable (see your computer's documentation). Turn over