Epson PowerLite 1930 Quick Setup and Warranty - Page 2

4 Press the power button on the projector or remote control. The projector beeps, the power light flashes green, and then stays on. Using the remote control Make sure the batteries are installed as shown (two AA batteries).  Note: To shut down the projector, press the power button twice, then unplug it. You don't have to wait for the projector to cool down. 5 The default language of the menu system is English. To select another language, press the Menu button on the projector or remote control. Select Extended and press . Select Language and press . Select your language and press . Press the Menu button to exit the menu system. Adjust the image 1 If you don't see an image, press the Source Search button on the projector or the remote control to select the image source.  Note: If you still see a blank screen or have other display problems, see the troubleshooting tips on the back of this sheet. 2 To raise the image, press the foot release button and lift the front of the projector. Release the button to lock the foot in position. 3 Turn the zoom ring to reduce or enlarge the image. WT Turn projector on and off Choose which source to display Access projector menus Turn off projector display Navigate projector menus Get solutions to common problems For more information on using the remote control, see the online User's Guide. Project over a wired network Follow the steps here to configure your projector for your wired network using the projector's menu system. 1 Plug in and turn on the projector. 2 Press the Menu button on the remote control, select the Network menu, and press . 4 Turn the focus ring to sharpen the image. 5 If your image looks like or , the projector has been positioned at an angle to the screen. Place the projector squarely in front of the screen. If you can't move the projector, use the horizontal keystone slider on the projector to correct the image. 3 Select Network Configuration and press . 4 Select the Basic menu and press . 6 Your projector automatically adjusts images that look like or , but if necessary you can press the or button on the projector to correct it.