Epson PowerLite 53c Product Information Guide - Page 7

EPSON PowerLite 53c/73c Projector Status lights Power light - - - - Orange Flashing green Green Flashing orange Warning light Flashing red Flashing red (quickly) Red Flashing orange (quickly) Off Off Off Off Status Description Internal error There is an internal error in the projector. Turn the projector off and unplug it. Contact EPSON for help. Lamp failure The lamp is burned out or not installed correctly, or the lamp cover is open. Close the cover or replace or reseat the lamp, if necessary, as described on page 10. Overheating The projector has overheated and turned itself off. Let it cool for a few minutes, then turn it back on. Make sure there is plenty of space around and under the projector for ventilation. Also clean the air filter (see page 9). If it continues to overheat, you may need to replace the air filter. High temperature warning The projector is too hot. Make sure the temperature surrounding the projector does not exceed 95 °F and there is plenty of space around and under the projector for ventilation. Clean the air filter, if necessary. See page 9 for instructions. Sleep mode The projector is in sleep mode. You can unplug it or press the P Power button to turn it on. Warming up The projector is warming up. Wait for the image to appear. Operating The projector is operating normally. Cooling down The projector is cooling down. Wait for the light to stay lit orange without flashing before unplugging it. Using the Remote Control Before using the remote control, pull out the tape from the battery tray as shown below. Tape When using the remote control, stand within 20 feet of the projector. Point the remote control either at the front or back of the projector or at the screen (the projector's front sensor can detect signals bounced off the screen). Press the button for the function you want to use. See the following pages for instructions. Note Most of the projector's features can only be accessed with the remote control. To avoid losing the remote control, place it in the remote control storage compartment beneath the side of the projector. Page down Page up Power Computer S-Video/Video Color Mode Menu A/V Mute Freeze E-Zoom Enter Auto ESC Switching Between Picture Sources If you've connected your projector to a computer and a video source, you can use the buttons on the remote control to switch between the different sources. ❏ Press the Computer button to select your computer source. ❏ Press the S-Video/Video button to select an S-Video or standard composite video source. After you select a source, the screen goes dark for a moment before the image appears. 11/02 EPSON PowerLite 53c/73c Projector - 7