Epson PowerLite 73c Product Information Guide - Page 10

EPSON PowerLite 53c/73c Projector Replacing the Lamp The projection lamp typically lasts for about 1500 hours of use. It is time to replace the lamp when: ❏ The projected image gets darker or starts to deteriorate. ❏ The warning light is flashing red. ❏ The message LAMP REPLACE appears on the screen when the lamp comes on (after about 1400 hours of use). To maintain projector brightness and image quality, replace the lamp as soon as possible. Note To see how many hours the lamp has been used, see page 11. Contact your dealer or call EPSON at (800) 873-7766 in the United States for a replacement lamp. Request part number V13H010L21. In Canada, please call (800) 463-7766 to locate a dealer. Follow these steps to replace the lamp: 1. Turn off the projector, wait for the cool down period to end, then unplug the power cord. 5. Use the screwdriver to loosen the two screws holding the lamp in place. The screws are deep inside the projector on the sides of the lamp. (You can't remove the screws.) Don't remove these screws 6. Hold the lamp by the top, as shown, and pull the lamp straight out. 2. Allow the projector to cool down for at least one hour (if it has been on). Warning Let the lamp cool before replacing it. If the lamp breaks, handle the shards carefully to avoid injury. 3. Turn the projector upside-down to access the lamp compartment. 4. Use the screwdriver included with the replacement lamp to slide the edge of the lamp cover towards the side of the projector. Then lift off the cover. ) 1 Warning This product includes a lamp component that contains mercury. Please consult your state and local regulations regarding disposal or recycling. Do not put it in the trash. 7. Gently insert the new lamp as shown below. Caution Do not touch the glass portion of the lamp assembly. Touching the glass could result in premature lamp failure. 8. Once the lamp is fully inserted, tighten its screws. 2 10 - EPSON PowerLite 53c/73c Projector 11/02