Epson PowerLite 765c Quick Start - Page 1

Epson® PowerLite® 755c/ 765c Quick Setup 2 Turn the focus ring to sharpen the image. Turn the zoom ring to reduce or enlarge the image. 1 Turn On Your Equipment 1 Connect the power cord to the back of the projector and plug the other end into an electrical outlet. 2 Remove the lens cover. Focus Zoom 3 If your image looks like or , you've placed the projector off to one side of the screen at an angle. Place it directly in front of the screen, facing the screen squarely. 4 If your image looks like or , press the or buttons on the projector to correct it. 3 Remove the battery cover on the remote control. Locate the batteries that came with the projector and insert them as shown. Then replace the battery cover. 4 To turn the projector on, press the red Power button on the projector or the remote control. The projector beeps once, and the projector's Power light flashes green and then stays on. CAUTION: Before unplugging the projector... Shut the projector down properly: 1. Press the Power button twice. 2. When the orange light stops flashing and the projector beeps, you can unplug the projector. 2 Adjust the Image 1 To raise the image, press the blue foot release button for the front adjustable foot and lift the front. Release the button to lock the foot in position. 3 Choose a Presentation Method How do you want to get images to the projector? • To connect to a notebook, see "If connecting to a notebook" below. • To project over an 802.11g/b network, see "If projecting wirelessly" on the back of this sheet. Computer cable You must have installed the projector's EasyMPTM software and configured your projector and computer before you can project wirelessly. See your User's Guide for instructions. • To give a presentation stored on a memory card, see Chapter 5 in your User's Guide. Wireless card If connecting to a notebook... 1 Make sure you've turned on the projector and adjusted the image as described in sections 1 and 2. 2 Locate the computer cable that came with the projector. Connect one end to the projector's blue Computer/Component Video port. Connect the other end to your notebook's video-out port or monitor port. If you can't connect the cable to your PowerBook®, you may need to use an adapter. See your PowerLite 755c/765c User's Guide for instructions. 3 Press the Source Search button on the projector until your computer image is displayed.