Epson PowerLite 810p Quick Start

EPSON

®

PowerLite

®

600p/800p/810p

Quick Setup

Connect the power cord to your projector and plug the other end into a grounded outlet.

3

Connect the other end to your laptop’s video or

monitor port.

1

Turn on the projector first. To do so, press the red

Power

button.

The

power light flashes green as the projector warms up,

and the projection lamp comes on in about 30 seconds.

2

Turn on or restart your laptop. (Windows only: If you see a

New Hardware Wizard screen for a Plug and Play monitor, click

Cancel

.)

Turn Over

Press the red

Power

button twice, then let the projector cool while the

power

light flashes orange (about a minute). Once the light stops flashing and stays on,

it’s safe to unplug the projector.

Never unplug the projector when the

power light is green or flashing orange.

Locate everything

you’ll need

Plug in your projector

Turn on your equipment

Caution:

Before unplugging the projector...

For most setups, you’ll need just these two cables:

You won’t need to install any software.

1

2

Make sure your projector and laptop are turned off.

Connect one end of the computer cable to the

Computer 2/Component Video

port on the projector.

Connect the projector

to your laptop

power cord

computer cable

Follow these instructions to connect the projector

to your laptop. To connect other devices, such as

a VCR or desktop PC, see your

User’s Guide

.

power button

power light