Epson PowerLite 8200i Quick Start - Page 1
Epson PowerLite 8200i Manual
View all Epson PowerLite 8200i manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1 highlights
EPSON® PowerLite® 8200i/9100i Quick Setup Locate everything you'll need For most setups, you'll need just these two cables: power cord computer video cable You won't need to install any software. Connect the projector to your laptop 1 Make sure your projector and laptop are turned off. 2 Connect one end of the computer video cable to the Computer 1 (VGA) port on the projector. Follow these instructions to connect the projector to your laptop. To connect other devices - such as a VCR or desktop PC - and to use the remote control, see your User's Guide. 3 Connect the other end to your laptop's video or monitor port. If you can't connect the cable to your PowerBook®, you may need to use an adapter. See your User's Guide for instructions. Plug in your projector Connect the power cord to your projector and plug the other end into a grounded outlet. Turn on your equipment 1 Remove the lens cap. 2 Press the red Power button on the projector to turn it on. The power light flashes green as the projector warms up, and the projection lamp comes on in about 30 seconds. 3 Turn on or restart your laptop. (Windows® only: If you see this Add New Hardware screen, click Cancel.) power light power button Caution: Before unplugging the projector... To shut the projector down properly, press the red Power button twice. Let the projector cool while the power light flashes orange (about a minute). Once the light stops flashing and stays on, it's safe to unplug the projector. Never unplug the projector when the power light is green or flashing orange. Turn over